Study on the effect of porous fence on air quality and traffic noise level around a double-decked road structure

Fence for traffic noise control sometimes causes adverse effect on air pollution. Thus in this study, performance of porous fence as a tool for control of both air pollution and noise pollution was evaluated. A two-dimensional numerical model for flow and pollutant concentration and an analytical model for traffic noise were utilized in the analysis of a double-decked road structure with fences only at ground (Case 1) and at both ground and upper deck (Case 2). Porous fences were assumed only at the ground level since the solid fences at the upper deck usually leads to desirable result on air pollution. Effects of the variable porosity on air quality and noise level near road were evaluated. Obtained results showed: (1) flow pattern in leeward of fence was drastically changed at 40–50% porosity in Case 1 and 50% in Case 2. The porosity larger than 40% excluded presence of a circulation behind the fence. (2) Effect of porous fence on air pollution was different in Cases 1 and 2. In Case 1, the porous fence generally resulted in the reduction of air pollution at the ground level; on the other hand, in Case 2, it rather led to increase of the concentration. (3) Traffic noise level was also largely changed by the porosity of the fence; an example of simultaneous evaluation of the effects of porous fence on both air and noise pollution in Case 1 showed that the fence of 60% porosity leads to reduction of air pollution by 20% compared with solid fence case, and reduction of noise pollution by 4–6% in dB compared with no fence case, at l m high and 10 m from the road.     

Current state of yusho and prospects for therapeutic strategies

The mass food poisoning incident yusho occurred in Japan in 1968. It was caused by the ingestion of rice bran oil contaminated with polychlorinated biphenyls and various dioxins and dioxin-like compounds including polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDFs). Notably, PCDFs were found to contribute to approximately 65% of the total toxicity equivalent in the blood of yusho patients. Lipophilic dioxins are retained in the body for a longer period than previously estimated. Victims suffered from characteristic skin manifestations associated with non-specific systemic symptoms, neurological symptoms, and respiratory symptoms. The severe symptoms seen in the initial phase subsequently faded, but recently, improvements have scarcely been observed. The Yusho Group has been researching treatments for this condition. Several clinical trials with chelating agents or dietary fibers aimed at accelerating the excretion of compounds. While some treatments increased dioxin excretion, none provided satisfactory symptom relief. Concurrently, various phytochemicals and herbal extracts have been found to possess biological activities that suppress dioxin-induced toxicity via aryl hydrocarbon receptor or activate the antioxidant nuclear factor-erythroid 2-related factor-2 (NRF2) signal pathway, making them promising therapeutic candidates. Here, we summarize the current status of yusho and findings of clinical trials for yusho patients and discuss the treatment prospects.

     

Liquefaction process for a hydrothermally treated waste mixture containing plastics

Most landfilled plastic waste is a mixture or is in the form of composites with incombustible wastes such as glass, metals, and ceramics. After hydrothermal treatment, including a steam-explosion process, the separation of mixed waste (MW) into organic and inorganic substances becomes easy. However, the effect of hydrothermal pretreatment on the subsequent liquefaction of organic substances from MW is not obvious. In this study, the effects on the liquefaction of polystyrene and high-density polyethylene are discussed. Moreover, optimum conditions for the liquefaction of organic substances from hydrothermally treated MW are identified. By means of this hydrothermal pretreatment, including the steam-explosion process, polystyrene and high-density polyethylene can be significantly converted to oil by liquefaction at 300°–400°C. In comparison with liquefaction of hydrothermally pretreated mixed waste (HMW) at 300°–400°C with a batch type reactor, the yield of oil increases significantly on liquefaction using a semi-batch type reactor. It is considered that the radical chain and termination reactions among the radicals from HMW were inhibited in the semi-batch type reactor. On liquefaction of HMW in a semi-batch reactor, the conversion of HMW to oil was enhanced on increasing the liquefaction temperature to 350°C and the holding time to 60 min. Chemical Feedstock Recycling & Other Innovative Recycling Techniques 6     

Pore structure and adsorption properties of activated carbon prepared from granular molded waste paper

We have previously manufactured activated carbon using waste paper board, which was prepared by adding 8% phenol resin adhesive to torn waste newspaper and hot-pressing. In this study, the pretreatment process of the raw material was simplified; the waste paper was extruded to form granules. The activated carbon was manufactured by the carbon dioxide activation method using the granules as the raw material. The properties of the activated carbon were evaluated based on the pore structure, the iodine adsorption number, and the adsorption of toluene vapor in a sealed chamber. The activated carbon, which was manufactured at an activation temperature of 1100°C and a treatment time of 60min, exhibited a specific surface area of 1241m²/g and an iodine adsorption number of 1120mg/g. These results were similar to those obtained for two commercially available activated carbons. The extent of toluene vapor adsorption by this activated carbon was similar to that observed for the two commercial activated carbons over a period of 130min.     

Chemical and mineralogical evaluation of slag products derived from the pyrolysis/melting treatment of MSW

This paper provides the results of studies on the characteristics of novel material derived from pyrolysis/melting treatment of municipal solid waste in Japan. Slag products from pyrolysis/melting plants were sampled for the purpose of detailed phase analysis and characterization of heavy metal-containing phases using optical microscopy, electron probe microanalysis (EPMA), XRF and XRD. The study revealed that the slag material contains glass (over 95%), oxide and silicate minerals (spinel, melilite, pseudowollastonite), as well as individual metallic inclusions as the major constituents. A distinct chemical diversity was discovered in the interstitial glass in terms of silica content defined as low and high silica glass end members. Elevated concentrations of Zn, Cr, Cu, Pb and Ba were recorded in the bulk composition. Cu, Pb and Ba behave as incompatible elements since they have been markedly characterized as part of polymetallic alloys and insignificantly sulfides in the form of spherical metallic inclusions associated with tracer amounts of other elements such as Sb, Sn, Ni, Zn, Al, P and Si. In contrast, an appreciable amount of Zn is retained by zinc-rich end members of spinel and partially by melilite and silica glass. Chromium exhibits similar behavior, and is considerably held by Cr-rich spinel. The intense incorporation of Zn and Cr into spinel indicates the very effective enrichment of these two elements into phases more environmentally resistant than glass. There was no evidence, however, that Cu and Pb enter into the structure of the crystalline silicates or oxides that may lead to their easier leachability upon exposure to the environment.     

Formation of dioxins from combustion of polyvinylidene chloride in a well-controlled incinerator

Polyvinylidene chloride (PVDC; polymer of 1,1-dichloroethylene) was combusted with paper in a well-controlled, small-scale incinerator at an average grate temperature of 700 °C, and then dioxins (PCDDs, PCDFs, and coplanar-PCBs) formed in the exhaust gases were analyzed by gas chromatography/mass spectrometry. PVDC lowered the combustion temperature due to its less flammable character. The amount of total dioxins (PCDDs + PCDFs + coplanar-PCBs) formed in the exhaust gas was 58.0 ng/g of a combustion sample and its toxicity equivalency quantity (TEQ) value was 0.64 ng-TEQ/g. The amount of PCDDs formed in the sample ranged from 2.33 ng/g (Cl₈-isomer) to 0.048 ng/g (Cl₁-isomer). The lower the number of chloride, the less production of PCDDs. On the other hand, there was no relation between the number of chloride and PCDF formation. The amount of PCDFs formed in the sample ranged from 8.02 ng/g (Cl₂-isomer) to 4.46 ng/g (Cl₈-isomer). A polyvinylchloride (PVC) sample produced 207 ng/g of total dioxins and a PVDC sample produced 57.4 ng/g of total dioxins when they were combusted under the same conditions. An approximately equal composition of dioxin isomers was formed from PVDC and PVC samples. Paper was found to contribute to PCDF formation when it was combusted with plastics.     

Neighborhood influences on the diffusion of residential photovoltaic systems in Kyoto City,Japan

Environmental Economics and Policy Studies - This study investigates the factors influencing the diffusion of residential photovoltaic systems. Factors examined are related to social attributes,...     

Simulation of dioxin accumulation in human tissues and analysis of reproductive risk

Polychlorinated dibenzo-p-dioxin, polychlorinated dibenzofuran and dioxin-like polychlorinated biphenyl concentrations in human liver, kidney, fat, blood, muscle, richly perfused tissue (brain, lung etc.) and skin were simulated to assess the health risk for Japanese fetuses. A 40-year time course of dioxin accumulation via food ingestion was simulated using a physiologically based pharmacokinetic (PBPK) model. In richly perfused tissue, the concentration estimated by the PBPK model showed better agreement with measured concentrations than that calculated by the one-compartment model. Fetal dioxin concentration was simulated based on the assumption that the fetal concentration was almost equal to the concentration in the mother's richly perfused tissue. To assess the reproductive risk, the estimated concentration in human fetus was compared with that in rat fetus in which reproductive function showed signs of alteration by 2,3,7,8-TCDD in previous reports [Toxicol. Appl. Pharmacol. 114 (1992) 118; 146 (1997) 11; Toxicol. Sci. 53 (2000) 411; 57 (2000) 275]. The present daily intake of 2,3,7,8-TCDD is approximately 1/50 of the amount that leads to possible reproductive toxicity in the next generation. However, when 29 kinds of dioxin congeners are considered, the present level is 1/5 of the hazardous levels. For species extrapolation of dioxin risk, further study on tissue concentration versus toxicity is required.     

Isomer distribution of nitrotriphenylenes in airborne particles, diesel exhaust particles, and the products of gas-phase radical-initiated nitration of triphenylene

The formation of mutagenic nitro-polycyclic aromatic hydrocarbons (NPAHs) 1- and 2-nitrotriphenylene (1- and 2-NTP) via gas-phase OH or NO₃ radical-initiated reactions of triphenylene was demonstrated for the first time using a flow reaction system. In contrast with the results of conventional electrophilic nitration, 2-NTP was formed in larger yield than 1-NTP, but this is consistent with the mechanism proposed for gas-phase radical-initiated nitration of PAH. In diesel exhaust particle (DEP) samples, both 1- and 2-NTP were identified and their concentrations determined, as well as 1-nitropyrene (1-NP), which is a representative combustion-derived NPAH: the mean concentrations of 1-NTP, 2-NTP, and 1-NP were 4.7, 1.9, and 32 pmol mg_DEP^–1, respectively. The mean 2-NTP/1-NTP, 1-NTP/1-NP, and 2-NTP/1-NP ratios in samples of airborne particles collected in a residential area in Osaka, Japan, were>1.55,<0.25, and 0.37, respectively; these values are much higher than those of the DEP samples. This finding indicates that there is another source for airborne NTPs, especially 2-NTP, apart from diesel exhaust. These results strongly suggest that airborne NTPs originate from atmospheric processes such as radical-initiated reactions of triphenylene, and this has a significant influence on the atmospheric occurrence of NTPs.     

Determination of tissue-blood partition coefficients for a physiological model for humans, and estimation of dioxin concentration in tissues

The tissue-blood partition coefficients for a physiologically based pharmacokinetic (PBPK) model were determined, and the concentrations of 17 congeners of polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) in tissues in Japanese people were estimated using the model. According to the PBPK model established by Lawrence and Gobas [Chemosphere 35 (1997) 427-452], we assumed a steady-state fugacity model for Japanese people in general, and set the route of PCDD/Fs exposure only from food intake. The required partition coefficients for liver, kidney, adipose, muscle, skin, bile, gut and viscera (richly perfused tissue) were calculated using available autopsy data from eight Japanese men and women who were not accidentally exposed to PCDD/Fs. For validation of the partition coefficients, estimated PCDD/F concentrations in liver, kidney, fat, blood and muscle using the model were compared to other two sets of measured concentration data in Japanese tissues. Good agreement was obtained between estimated data and measured data, and most of the measured data were within the simulated concentration range in liver, kidney, blood and muscle. From these results, our model and calculated partition coefficients seem applicable for the estimation of congener-specific concentrations in human tissues.